Software User's Guide Version 3.3

Tables

1. Processes, Their Purpose, and Commands to Access
2. Network Architecture and the Supported Interfaces
3. OPCON Commands
4. Change Management Configuration Commands
5. Service Recovery Commands
6. Quick Config Capabilities
7. CONFIG Command Summary
8. Access Permission
9. IBM 2212 Feature Numbers and Names
10. Additional Functions Provided by the Set Prompt Level Command
11. Default and Maximum Settings for Interfaces
12. GWCON Command Summary
13. Logging Levels
14. Packet Completion Codes (Error Codes)
15. ELS Configuration Command Summary
16. ELS Net Filter Configuration Commands
17. ELS Message Buffering Configuration Commands
18. ELS Monitoring Command Summary
19. ELS Net Filter Monitoring Commands
20. ELS Message Buffering Monitoring Commands
21. PERF Configuration Command Summary
22. PERF Monitoring Command Summary
23. Token-Ring Configuration Command Summary
24. Token-Ring 4/16 Valid Packet Sizes
25. Token-Ring Monitoring Command Summary
26. LLC Configuration Command Summary
27. LLC Monitoring Command Summary
28. Configurations That May Result in Link Failure on the IBM 2212
29. Configurations That May Result in Mismatched Duplex Modes During Operation
30. 10/100-Mbps Ethernet Configuration Command Summary
31. Ethernet Monitoring Command Summary
32. Set Command
33. National Enable Parameters
34. National Set Parameters
35. Establishing Incoming X.25 Circuits for Closed User Groups
36. X.25 Configuration Commands Summary
37. Example VC Definitions
38. X.25 Monitoring Command Summary
39. XTP Configuration Commands Summary
40. XTP Monitoring Commands Summary
41. Protocol Address Mapping
42. Frame Relay Management Options
43. Frame Relay Configuration Commands Summary
44. Frame Relay Management Options
45. Transmit Delay Units and Range for the 2212 Serial Interface
46. Frame Relay Monitoring Commands Summary
47. LCP Packet Codes
48. Point-to-Point Configuration Command Summary
49. Point-to-Point Monitoring Command Summary
50. MP Configuration Commands
51. MP Monitoring Commands
52. SDLC Relay Configuration Commands Summary
53. Valid Values for Frame Size in Set Frame-Size Command
54. SDLC Relay Monitoring Commands Summary
55. SDLC Configuration Commands Summary
56. Valid Values for Frame Size in Link Frame-Size Command
57. SDLC Monitoring Commands Summary
58. BSC Relay Configuration Commands Summary
59. Valid Values for Frame Size in Set Frame-Size Command
60. BSC Relay Monitoring Commands Summary
61. V.25bis Configuration Commands Summary
62. V.25bis Monitoring Command Summary
63. V.34 Configuration Commands Summary
64. V.34 Monitoring Command Summary
65. ISDN Q.931 Cause Codes
66. ISDN Configuration Command Summary
67. ISDN Modem Configuration Command Summary
68. ISDN Cause Codes Command Summary
69. ISDN Monitoring Command Summary
70. Digital Modem Monitoring Command Summary
71. Dial Circuit Configuration Commands Summary
72. Dial Circuit Configuration Commands Summary